You will now find the complete range of high quality Data Loggers from the ...
Se fler nyheter
Hjem › EMC produkter › Tilbehør › Tekbox EMCview PC-software for EMC pre-compliance testing of radiated and conducted emissions
Tekbox EMCview PC-software for EMC pre-compliance testing of radiated and conducted emissions
Klik på billedet for at forstørre
One license is valid for one spectrum analyzer. Please send the serial number of your Rigol spectrum analyzer in the comment box during checkout or in an email to firstname.lastname@example.org. We will send you the license file in 24 hours.
EMCview currently supports spectrum analyzers from Rigol and Siglent. The spectrum analyzer should also be equipped with the EMI option. Support for other spectrum analyzer manufacturers will be added in future SW versions.
EMCview V2.02 and upcoming revisions can be downloaded from TekBox website from now on.
Limitation without license: the measurement is limited to the frequency range below 10MHz
Numerous pre-configured project files for CISPR-xx (EN550xx) emission measurements
Graph supports two complete measurement runs, same as in test house
Fast Quasi-Peak scan of critical peaks, immune to frequency drift of the selected peaks Configurable limit lines and segment files
Configurable correction files for cable, LISN, amplifier, antenna etc.
configurable margins for the identification and selection of critical peaks
Supports import and overlaying of reference measurements for comparison purpose
Linear or logarithmic frequency axis
Automatic creation of test reports
In house measurement of EMC behavior during product design phase
EMC training in lab, school and university
Pre-compliance test of products before submitting it to the test house
Test cost reduction
Reduced time to market
Tekbox EMCview is a PC-software for user friendly EMC pre-compliance testing of radiated and conducted emissions.
It is a perfect complement for automated testing using Tekbox LISNs and TEM Cells.
A built in amplitude correction enables correction and conversion coefficients for cables, amplifiers, attenuators, LISNs, TEM cells, antennas, RF current probes, striplines and capacitive coupling clamps.
There is no need for a time consuming setup.
The SW is ready for measurements straight after installation.
All emission related CISPR-xx (EN550xx) measurements and a few automotive manufacturer standards are pre-configured in corresponding project files.
The graph supports two complete measurement runs such as for example Average / Quasi-Peak or Peak / Quasi Peak and alternatively a fast Quasi-Peak scan of critical peaks.