- Dual baseband arb generators
- Analog and vector modulation
- I/Q modulation inputs (300 MHz RF BW)
- ASK, FSK, MSK, PSK, QAM, VSB & custom I/Q
- Presets for GSM, EDGE, W-CDMA, APCO-25, DECT, NADC, PDC, ATSC-DTV and TETRA
- GPIB, RS-232 and Ethernet interfaces
The new RF Signal Generator SG394, with carrier frequencies from DC to 4.050 GHz, support both analog and vector modulation.
The instrument utilize a new RF synthesis technique which provides spur free outputs with low phase noise (-116 dBc/Hz at 1 GHz) and extraordinary frequency resolution (1 μHz at any frequency).
Both analog modulation and vector baseband generators are included as standard features.
The instrument use an ovenized SC-cut oscillator as the standard timebase, providing a 100 fold improvement in the stability (and a 100 fold reduction in the in-close phase noise) compared to instruments which use a TCXO timebase.
OCXO or Rubidium Timebase
The SG390 Series come with a oven-controlled crystal oscillator (OCXO) timebase.
The timebase uses a third-overtone stress-compensated 10 MHz resonator in a thermostatically controlled oven.
The timebase provides very low phase noise and very low aging.
An optional rubidium oscillator (Opt. 04) may be ordered to substantially reduce frequency aging and improve temperature stability.
An external 10 MHz timebase reference may be supplied to the rear-panel timebase input.
Remote operation is supported with GPIB, RS-232 and Ethernet interfaces.
All instrument functions can be controlled and read over any of the interfaces.
Up to nine instrument configurations can be saved in non-volatile memory.