HjemBænkinstrumentKalibratorer og NormalerKapacitansAndeen-Hagerling AH 11A fused-silica capacitance standards

Andeen-Hagerling AH 11A fused-silica capacitance standards

Andeen-Hagerling AH 11A fused-silica capacitance standards
Klik på billedet for at forstørre
Andeen-Hagerling AH 11A fused-silica capacitance standards

Ease of Shipping

AH 11A standards may be sent for calibration by shipping the entire AH 1100 frame containing up to four standards.

Alternatively, if the calibrating lab has an AH 1100 frame, then only the AH 11A standards that are to be calibrated need be sent.

These are easily removed by removing the top cover of the AH 1100, disconnecting three cables from each AH 11A, and loosening four mounting screws. The calibrating lab installs the AH 11A in that lab's AH 1100 frame to perform the calibration.


The AH 1100/11A system is much more impervious to its environment than other capacitance standards.

The AH 1100 and AH 11A's can be shipped in a well cushioned box comparable to that used to ship other precision instruments.

With such packaging, no other special handling requirements are necessary.

The small thermal hysteresis of the AH 11A means that it does not need to be shipped at its operating temperature. This eliminates the need to include heavy batteries in its shipping container. 




Spørg om pris/offert




User-Selected Values

AH 11A capacitance standards can be ordered with any value from below 1 pF up to 115 pF. Furthermore, if the application for which the original value was purchased becomes obsolete, the AH 11A can be returned to the factory and set to a totally new value for a nominal cost.

Traditionally, capacitance values for transfer of higher echelon calibration values have been chosen to be several parts per million above 10, 100 and 1000 pF.


The AH 11A can be ordered with values such as these for 10 and 100 pF. For applications requiring calibration of an AH 2500A capacitance bridge, values near 100 pF are preferred to those near 10 pF. In fact, for calibration of an AH 2500A at a single value, Andeen-Hagerling recommends using an AH 11A standard having a value of 99.99950 pF.

This is 5 ppm below 100 pF. Values slightly below 10, 100, or 1000 are preferred to those above since this allows the capacitance bridge to most conveniently display an additional digit. Otherwise, the exact choice of values should be based on convention, personal preference, and standardization among groups that are exchanging calibration values. 


 »Read more 

Instrumentcenter Sweden AB, Box 233, 611 25 Nyköping - Sweden. | Tel: +46 155 26 70 30, Fax: +46 155 26 78 30.
Delivery address: Folkungavägen 4, 611 34 Nyköping, Sweden
E-post: info@instrumentcenter.se  International phone +46 155 26 70 30  Fax +46 155 26 78 30